Professional Rain Maker / Reptile Mister System

This Professional Rain Maker / Mister System is suitable for creating a rainforest system for all kinds of reptile tanks and plant tanks, which can achieve the spraying or dripping effect. It can be quickly installed inside a tank, and the accessories are abundant enough to meet various feeding demands.

It uses the diaphragm silent pump, which realises low functional losses and stable operation, and the spray head can spray to multiple angles and a wide spray range. Instant water returning function once the product stops working. There are four rubber pads on the bottom of the engine to reduce noise.

How to use

1 - Place the sprinkler main engine on a flat surface next to the tank.

2 - Cut the length of the inlet pipe according to the actual needs, then connect the filter head to one end and insert the other end of the pipe into the water inlet quick connector (IN) of the machine. Put the inlet pipe with the filter head into the water tray or other suitable water source, but ensure that the water source is clean, otherwise the filter head will be easily blocked.

3 - Cut the appropriate length of the water outlet pipe according to the actual needs, then connect the four spray head components to one end according to the actual position, then install the plug at the other end, and place the spray head in the required place. Press the suction cup tightly to discharge the internal air to ensure that the suction is firm, and then connect the other end to the outlet quick connector of the machine (OUT).

4 - After installation of the product, insert the output plug of the power adapter into the power cords of the mister, and then connect it with power supply. When the machine is running normally, check if the spray head spray is normal.

5 - In order to avoid water leakage, when cutting the water pipe, please make the cutting edge even and make the water pipe and the quick connector tightly connected.

6 - The maximum suction head of the machine is 2M, that is, the height from the water source surface to the plane of the machine should not exceed 2M, otherwise it may not be able to absorb water upwards to position. When it works after the first use or water cut, the machine will have difficulty in sucking water because there is a lot of air in the machine. At this time, temporarily lower down the plane of the machine to the water source surface, so that the machine would be able to absorb water easily, and put the machine back to its original position after it functions well.

Accessories/ Spares also available